Project case study

Mercavio Factory Roof — Ajman Project Reference

A 288 m2 Ajman factory metal-roof project originated and specified by CoolRoof UAE. The site is presented as a commercial project and object reference, with real project-route media.

Project reference: CoolRoof originated and prepared the technical route. The completion is presented as an object reference only; CoolRoof does not claim execution, supervision, warranty or a measured result for that completion.

Project facts

Project type: Factory metal-roof project reference
Location / emirate: Ajman, UAE
Roof area (m²): 288 m2 (16 m x 18 m stated roof size)
Roof type: Metal / iron factory roof
System used: CoolRoof's original route was a light, two-pass reflective Sikalastic-525 RoofPro GCC coating specification. This page presents that project-route specification, not a CoolRoof execution record.
Duration: Original CoolRoof scope was not executed by CoolRoof; no CoolRoof completion duration is claimed.
Warranty route: No CoolRoof warranty applies to the independently completed work.

Client problem

The client requested a reflective roof-coating route for heat reduction on a straightforward factory metal roof. The original CoolRoof brief excluded major corrosion repair, full reinforcement, heavy waterproofing reconstruction and major leak repairs unless separately confirmed on site.

Materials

Original CoolRoof specification: Sikalastic-525 RoofPro GCC reflective coating, planned as a light two-pass route.
The actual completed-work materials are not represented here as a CoolRoof supply or installation record.

Preparation

Original CoolRoof method: inspect sheets, screws, laps, seams, gutters and penetrations before coating.
Clean the metal roof, remove loose contamination and treat visible corrosion before any coating stage.
Confirm the roof is dry and use a metal primer or detail treatment where the substrate requires it.

Application steps

The CoolRoof technical route was to detail weak screws, laps, seams and penetrations where needed.
The field route was specified as two reflective coats with curing between coats.
The completed work is shown as a project and object reference; CoolRoof does not claim to have supervised, accepted or warranted that completion.